close
close

aberdiamond

th 445

How To Run Ethernet Cable Between Floors Without Drilling

How To Run Ethernet Cable Between Floors Without Drilling. Next downstairs, cut a j box hole in the same way you did upstairs. An ethernet cable connects one device to another, such as a computer.

wiring How should I run Cat5e cable between rafters
wiring How should I run Cat5e cable between rafters from diy.stackexchange.com

Pull a cable to a closet that lines up with a wall on the second floor (good) or a closet on the second floor (better), and run the line up the wall inside the closet, on the inside wall the door is cut out of, so you can’t see the wire even if you look into the closet. Strip the wires and attach them to the wall jack or run them to the device. Actually did a bit of this for the first run of ethernet cable.

7) Fish Tape Or Wire Coat Hanger.

Feed the wire through the back of the outlet box, insert the box in the wall, and mount it in place. Drill destination hole in floor. After drilling down from the floor above, i cut a small hole in the ceiling to find the hole inside the wall from the floor above.

Actually Did A Bit Of This For The First Run Of Ethernet Cable.

Next downstairs, cut a j box hole in the same way you did upstairs. How do you run ethernet cable between floors? I could run along a wall in the closet but then that will require drilling through the ceramic floor tiles and cutting notches in each closet shelf.

Finally, You Can Start To Run The Wires.

Powerline adapters are the closest thing to being able to do this. Drill destination hole in floor. Using a 24 long 3/4 bit, insert the drill bit into the j box hole, and drill through the bottom of the wall creating a path to the same wall downstairs.

If You Have Satellite Or Cable Tv, You May Experience Problems With Your Tv Boxes If You Use A Moca Adapter Over Coax.

Using a coat hanger i was able to thread the ethernet cable through the space and over to another small hole in the ceiling, where i was able to. Pull a cable to a closet that lines up with a wall on the second floor (good) or a closet on the second floor (better), and run the line up the wall inside the closet, on the inside wall the door is cut out of, so you can’t see the wire even if you look into the closet. Placing the mounts at every 4ft, place the ethernet cables into the mount and set it.

Use A Drill With A 3/4 Inch Bit To Drill Through The Subfloor, Making Sure The Drill Is Perpendicular To The Floor.

If necessary, use spackle to cover up additional gaps in your ceiling. Strip the wires and attach them to the wall jack or run them to the device. However running the cable along or around pipes or ducts probably isn't an option because the pipes and or ducts would probably pass through floor joists that were cut to allow the pipes to pass between floors, but i doubt there would be enough space to pass a cable as well through.

Leave a Reply

Your email address will not be published.